Setting a duct fiiting

With the “Set duct fitting” workflow, two ducts are connected to one another via a fitting. In the Industry Model options, various conditions that influence the workflow can be activated.

Procedure

Start the workflow in Workflow Explorer > Duct workflows > Set duct fitting by double-clicking it, from the context menu or by clicking the mceclip1.png button in the lower right area of the workflow explorer:

mceclip0.png

or in the NET Planning tab:

mceclip2.png

Note
Duct connections can also be added in the duct connection editor.

mceclip3.png

The following options are available for the workflow:

mceclip4.png

If the “Select duct-connection model in the workflow” option has been activated, the query for the fitting model (fitting type) will appear in the workflow.

mceclip0.png

The segment must be selected in the graphic that contains the corresponding duct or the duct itself is selected. The duct can be selected from the graphic or from the segment cross section.

mceclip0.png

The ducts assigned to the segment are displayed in a tree view and a duct can be selected.

mceclip1.png

Before selecting the second duct, the name and FID of the first duct are displayed.

mceclip2.png

The ducts assigned to the segment are displayed in a tree view and a duct can be selected.

mceclip0.png

The position of the fitting is defined in the graphic. Attention must be paid to the object snap.

mceclip3.png

Result

The mceclip1.png button in the duct form under the duct-assignment overview gives information on the duct connections of the current duct.

mceclip3.png

The form for the duct fitting is presented as follows:

mceclip1.png

The fitting can be shown as a duct point in the graphic.

mceclip0.png

Note
If subordinate ducts are disconnected in the “Disconnect ducts” workflow, the higher-layer duct is automatically connected to a fitting at the disconnection point.

NET Settings

The workflow is carried out depending on which NET Settings have been selected.

Option 1: mceclip0.png
If ducts of different duct types have been selected during the workflow, the following message will appear:

mceclip5.png

Option 2: mceclip1.png
If ducts of different colors have been selected during the workflow, the following message will appear:

mceclip6.png

Option 3: mceclip2.png
At the beginning of the workflow, the query about the fitting model is made:

mceclip4.png

Option 4: mceclip3.png
If a cable is assigned to one of the ducts that are to be connected via a fitting, the cable is assigned to both ducts after adding the fitting.